![leadshine vs gecko g540 stepper drive leadshine vs gecko g540 stepper drive](https://docs.masso.com.au/application/common/ui_assets/uploads/myimage76.png)
The good news is I can eat what I have invested in tooling, working material, shipping etc. If I'm, not smart enough to work CNC, I should have spent a fraction of what I spent on a old machine and put my energy into reviving it. As in most of those other cases where I have thought "new" was a good idea, I have a very bad taste in my mouth. My wife insisted that I should look at "new" when I was researching what I wanted. At almost 50 I can count on one hand the times I've purchased significant items "new". Everything I can think to do says my DB25 and cable are fine, so the all in one is a piece of crap and I'm stuck with that. I CAN'T change the pieces around because I got a POS all in one G540. Then, in a calmer moment, I realized you either aren't paying attention either or didn't read the entire thread. Such a setup probably costs a bit more alltogether, but in the end the fact that it costed a few bucks more is quickly forgotten when the result is a trouble-free setup that zips along nicely and quietly.įor the record, your reply initially confused me even more than I already am. It is very well designed and built, still pretty affordable, and there is a lot of experience with that hardware here on the forum. 5i25+7i76 comes to mind, but maybe there is a better/cheaper combination for your needs. To complement three of those drives you can get away using one of those $7 'Mach3' breakoutboards, but I would suggest to seriously consider Mesa hardware. The higher voltage and current capacity is also a much better match to your average NEMA34 motor.
LEADSHINE VS GECKO G540 STEPPER DRIVE SOFTWARE
Those drives are about as good as you can make a stepper drive, especially if you use the tuning software to adjust the drive perfectly to your motor (but you don't have to autotuning works OK).ĪM883 can be found on Ebay for relatively little money and is a world class drive with useful features such as stepper stall detection. I 'hate' the Leadshine M and ND drives, but I really like the Leadshine EM/AM and DM series.
![leadshine vs gecko g540 stepper drive leadshine vs gecko g540 stepper drive](https://image.made-in-china.com/202f0j00oTsUtJNykIcw/M860-Leadshine-Stepper-Motor-Driver.jpg)
![leadshine vs gecko g540 stepper drive leadshine vs gecko g540 stepper drive](https://www.509maker.com/wp-content/uploads/2016/10/G540.png)
But to be honest I never had one physically in hands. Whenever I see people fiddling with those resistors to set current and wire up motors to a sub-D, being stuck with a fixed 10-step microstepping, etcetera I cannot help thinking of Gecko drives as 'stone age technology'.